Quote from: GenTarkin on August 31, 2015, 08:39:35 PM

Is the LM75 the actual temp sensor itself as well? if it is then measuring the temperature on that location of the board is purely a freaking ambient temp - "inside of the cube" temp ROFL! Thats quite useless, thanks KNC.

As far as I'm concerned, kfc put the LM75 as far as possible away from the chip to try to hide how stupidly hot their chips were getting. This was my thoughts the moment they released photos of the neptune boards.

Quote from: The Avenger on June 07, 2014, 01:55:07 PM

BTW, anyone else notice how they put the component that reports the chip temperature at the very *edge* of the board, far far away from the chip? Is this a tell that KNC expect Neptune to have heat/overheating problems?

If you have a few big fans blasting air over this, it is not going to report anywhere near the correct chip/board temperature. It looks like KNC are misrepresenting - by design