Quote from: notlist3d on September 07, 2015, 09:22:39 AM

Quote from: Tupsu on September 06, 2015, 05:48:04 PM

Quote from: gerardo15 on September 06, 2015, 05:43:11 PM

Quote from: Tupsu on September 06, 2015, 02:10:42 PM

Obviously, this is boards problem.
They are sometime overheated and now we have some chips with poor contact.

My recommendation. Turn the controller to the other side, so that data cables can be exchanged. It is only four screws, at Controller metal frame.
Check , the error is repeated on the same blades or not.

Come on, i would know if the problem it's the controller board im talking that 22 miners from different batch do the same thing! and people here come and say to check the PSUs.. it's like they are not reading what i typed..

What are the odds that me and my friends have bought 22 miners with the left BOARD with problems???

What are the odds that You and You friends have bought 22 miners with the controller board problems???

I think this must be a tad exaggerated. Just the chances of 22 miners having same problems are slim. Did the same person setup all of these miners?

I read the PSU's do you have any that are a little bit higher quality? Those are all ok... none great. But I suggest posting some networking screens, status screen, etc. I think 22 miners something chances are something was set wrong.

Each of us setup the miners, but out of curiosity.. miners are basicly plug and play, you just connect 4 PCIE, connect RJ45, set up pools.. leaving default frecuency on all miners. All temperatures are bellow 58, where could posibly be room for a wrong setup?