Quote from: edonkey on September 14, 2015, 08:07:30 PM

Oh, oh. I tried to build with icarus and gekko support (following my own recipe above) and I got a compile error:

Code:

make[2]: Entering directory '/var/www/minera/minera-bin/src/cgminer-gekko'
CC cgminer-cgminer.o
cgminer.c:237:7: error: redefinition of opt_anu_freq
cgminer.c:229:7: note: previous definition of opt_anu_freq was here
cgminer.c:240:7: error: redefinition of opt_rock_freq
cgminer.c:232:7: note: previous definition of opt_rock_freq was here
Makefile:782: recipe for target 'cgminer-cgminer.o' failed
make[2]: *** [cgminer-cgminer.o] Error 1

Novak, could this be a copy/paste issue where a variable got reused without being renamed?

That one might be on me for failing to gut all the icarus related stuff out of compac drivers. I've been collecting some small things that need to be repaired and I'll probably post an updated version soon. As far as your fix where you deleted the duplicate lines that's fine unless you don't build with --enable-icarus, because there are still apparently references to opt_anu_freq in driver-gekko.c. As I said, I have them cleaned up in my current working version and should have it out for you guys soon. I'll try to test with the u2 as well.

Quote from: WBF1 on September 14, 2015, 08:14:03 PM

Does cgminer-gekko come with xnsub for nicehash or do I need to patch it in myself?

It's the same as stock 4.9.2, so, no.

Quote from: notlist3d on September 14, 2015, 08:30:37 PM

Quote from: mindtrip on September 14, 2015, 08:27:54 PM

So flat edge flush with bottom would be what voltage about?

It would depend which way you turned it. Did you turn right or left and how much? Could be .8 or .55 depending on that or between.

Not sure what you mean but no, it's always the same voltage. About 0.68V.

--
novak