Quote from: ngzhang on November 29, 2015, 08:46:02 AM

Quote from: RichBC on November 29, 2015, 08:33:21 AM

Can you give a brief explanation of the temperate issue that is being discussed, does the miner really need to run at a minimum of75C ? Also an outline of the algorithm that SmartSpeed is using would be very instructive?

Thanks

Rich

About temperate:

Next Cgminer software will adjust the default target tempature to ~68-70C. 75C is safe but a little high (too clost to the cut-off tempature).
Also, taget tempature can be set by user in next cgminer update.

About smartspeed:

This is a very complex system, partly built in the ASIC. Will add new algorithm in software side to optimize down clock and under voltege
condition later (may not finish in next update). But fully disable smartspeed is not recommend (will course a very high DH% and lost
20-50% real speed), so there will not a "DISABLE" switch.

ng

Thanks for the information it's great to hear that you are planning an update to down clock the A6!

I know it's a long shot but do you have any theorised, tested or project numbers around the down clock?