Quote from: tadsligar on December 17, 2015, 09:43:34 PM

You didn't seem concerned that the controller version was blank before. This is where you are supposed to get your firmware version according to your guide. So, that tells me something is maybe wrong with it. So, I tried to reinstall the firmware. I did it from within the openWRT portal and nothing changed but it seemed to work ok. Controller version was still blank.

I saw your note where I should just reflash the SD card. So I tried that, and now I can't even get it to connect to the internet.

I downloaded the one at http://downloads.canaan-creative.com/software/avalon6/openwrt/latest/pi-modelb-v2/openwrt-brcm2708-sdcard-vfat-ext4.img

And then I just wrote that to my SD card. Was that the right one?

ugh... I hope zoomhash either lets me open up the case or will accept this back and return my money.

I used Win32DiskImager to write "openwrt-brcm2708-sdcard-vfat-ext4.img" to an SD card and inserted it into the Rasp Pi. I connected an HDMI and nothing boots up. The RaspPi turns on but no OS loads up. Am I doing something wrong? Do I need to install the RaspPi OS individually or something now?

I was trying to setup the Avalon to run wireslessly but now I can't even get any OS to boot up.