Quote from: dog1965 on February 03, 2016, 08:40:31 AM

...

also second question what do I put into the antminer S7 and S5 as far as username/?+? you know the difficulty stuff here is my config line for the s7

Huh

???NaahqHpLiZt9GPXUkFoPkQmz4dMH.ant1/2055000 was using the + to but took it out.

Short complete P2Pool difficulty guide:

There are 2 allowed switches that you can include after your address/username in P2Pool.

They are defined in work.py starting on line 167.

The "+" = desired_pseudoshare_target

Pseudoshare Target instructs the pool node to provide your miners with work at a FALSELY low difficulty, a difficulty lower then the actual share difficulty. This is beneficial because it allows the graphs on the front end to smooth out instead of just showing spikes, and allows the node to more accurately guess your true hash rate.

The "/" = desired_share_target

Share Target actually sets the real share difficulty for your miners. Any share target below the current P2Pool minimum target is ignored and the minimum P2Pool target difficulty is used, currently 2,180,000

These are the only 2 allowed switches, adding anything else may break your payout address.

Example:

YOUR_BTC_ADDRESS/SHARE_TARGET+PSEUDOSHARE_TARGET

Note: NastyPool had added custom switches to facilitate their PoP payout method, this is specific to their node only.