Quote from: Jayjay04 on April 17, 2016, 04:23:23 AM

Quote from: notlist3d on April 16, 2016, 06:34:03 PM

Quote from: pattim on April 16, 2016, 02:46:00 PM

It can be hard to find that little reset button with a paperclip. You have to make sure you found it - you'll hear a subtle, little "click" when you find it and press on it. You sure you found it?

It's not always behind the hole to. Like when you say it can be hard to find he might need to use paper clip and go in a circle within hole trying to find it. Once he does find it though I would also ask him to make sure he's holding long enough. Some just press it and think it resets you have to hold longer then a instant push to do the reset I think hes going for.

Also don't know his firmware but one had a issue where you could not reset... so hope hes not on that firmware.

yeah yeah don't worry done it plenty of time.... I think the board is corrupted...

The board could have a problem, I once had one that messed up during a update and electricity was lossed. I bought a new S3+ IO board programed with firmware since mine was bad flash. If you have a bad flash or something it can be done with serial to usb cable I believe.

And there really was one firmware I believe reset button did not work so if you had that firmware it could be a issue there. Been a while since I messed with S3's.