i dont understand what you are saying..
the fans only go to 100% when the miner itself is first powered on.. then it reboots and the fans are set to the speed you specify.
my script doesnt reboot the whole miner, just cgminer.
the only time my script sets the fans to 100% is if the boards go over 70c.
unless it needs 100% to keep them between 60-65 avg temp.
my s7s are usually around 40-45% fan.
OK sorry I know what I said was confusing. I'm testing these at home and want to try your script and am just trying to figure out if it will help with the startup noise referred to below. I've been restarting the s7 at the wall a lot. This is approx what I'm hearing with fans.
At Boot: first 60 seconds quiet barely any fan.
seconds 60-85: loud 100% fan
seconds 85-100: fan slows to my manual setting of 30%
seconds 100-105: fan kicks back up to 100%
seconds 105+: fan goes back down to manual setting 30%
Thx for reply above, I'm going to give your script a shot and see what changes.