Quote from: wll1rah on October 01, 2016, 05:09:36 AM

Quote from: adamvp on September 29, 2016, 03:13:28 AM

Quote from: Claymore on September 28, 2016, 07:55:27 PM

Quote from: adamvp on September 28, 2016, 07:37:58 PM

another issue with Linux version, from few days it constantly switching SIA pools every 30-40minutes..
Windows version is ok, even if I revert rigs :S

Code:

SC: http error #28.
SC: Failed to check work on pool, retry in 10 sec..

This error code means "operation timeout".
I can say again and again: don't use Linux if you can use Windows! Most problems are related not to miner but to Linux itself and I have to find workarounds all the time.

Hmm Windows is too expensive, and is unstable if miner crash =windows crash and hard reset is necessary. If on linux fail = just kill the process

you can do the same on windows and it isn't to expensive since you can buy a POS tablet and use the product key from that, which you can get using slmgr or grab from the bios since they usually enable secure boot.

what is a POS tablet?

Quote from: tlmoscow on October 01, 2016, 01:57:17 PM

Quote

is it a known issue with rx 480 8gb that it takes 60-90 seconds after showing "POOL/SOLO version" for the miner to proceed to DAG generation?
happens on all my 4 rigs with windows 7/windows 10

Try to press anykey when miner window in focus...

I tried that, it's not because console scrolling is stuck. It's something else. Seems very random sometimes.