Quote from: Fujitzo on February 16, 2017, 03:58:36 PM

Quote from: volapyk on February 16, 2017, 02:22:54 PM

There seems to be an issue with -li mode.
I have tested out -li 2 and -li 8 for alle cards (unmodded rx 480)

I get the same sol/s reporting rate when running with -i 6. But far lass power use. But in the pool I only get about half the sol/s when running with -li 2.
Could there be a reporting error when running low intensity mode?

Exactly! Once I installed v12 I got stability problems on all 3 rigs (mixed 280s and 290s) I guess from the heavier Vram utilization, which is clocked to 1500 on all cards (no bios mod, just MSI aft) So I read here about the li mode, so I switched it on and noticed immediate 20% drop in consumption and same hashrate in miner. Thought hm... too good to be true ?? But ok, let's give it a try. I mined in coinmine.pl pool for 1 night and the reported by pool speed was more than 30% lower over this period. I switched to flypool - the same. Finally removed li mode and speeds in pool improved (and payouts consequently) but are still quite far from speeds in miner. In miner I get 5300 H/s total in the pool is like 4300 - 4700 which is a whopping 17% difference. They say pool luck.. ok, but then I should be getting speeds ABOVE what I see in miner from times to times, right? So if this is due to variance the 24h average should be pretty close to what I see in miner. Why is such a big difference ?

Anyone else have such a big gap in reported speed in miner vs pool? Have you tried several pools and noticed which one is closest to speeds in miner?

Cheers

yes, the only pool where i see an accurate hash is at dwarf but they are way too small and luck goes up and down like a rolercoaster