Quote from: bumbacoin on April 02, 2017, 02:53:41 AM

Quote from: voss836 on April 02, 2017, 02:06:32 AM

Quote from: bumbacoin on April 02, 2017, 01:49:44 AM

Quote from: voss836 on April 02, 2017, 01:31:52 AM

I've been trying to follow this guide for masternode setup
http://bumbacoin.blogspot.com.au/2016/07/how-to-setup-exclusive-coin-master-node.html
however I don't have the line "addrlocal". Do you know how to fix this? Also with the .conf file, I just added what was in that guide, plus the code pasted in here a few posts back. Did I just save it as a .conf file and that's it?

the guide uses the inbuilt functionality of the wallet,
so it will auto create the file masternode.conf

addrlocal is yr wallet ip address.
it might work ok without it. i've never tested.

but ..
if you dont have the line then it seems you're not doing it right

this is the relevant bit ..
i've modified it slightly hopefully for a tad more clarity

Code:

to get your address:port
go to debug console and enter
"getpeerinfo"

I've tried that but it's not working. All I've done so far is send 5000EXCL to a new address in the wallet. Is there anything else I need to do beforehand?

are you getting any output from that command ?

you need the 5000 coins, then the masternode.conf filled out, then it should work.

I'm getting an output from "getpeerinfo", it just doesn't include addrlocal.
How do I fill out the .conf file? I thought you said this was automatic? I'm not the best with computers so sorry if it's obvious