Quote from: lakat on April 20, 2017, 09:43:01 PM

Quote from: TracerX on April 20, 2017, 09:23:14 PM

Quote from: lakat on April 20, 2017, 09:08:13 PM

I got today my new Baikal Cube miner.
When I deleted the default pools and add my new pool settings the miner is not starting. I was clicking the save pools button. This is on Miner Down state.
When I try restart with cgminer soft reset button I got an "Miner:111 Connecton refused" error message.

The red led on the miner is on , the blue is blinking and the green is off state.

How can I start the miner? Is possible an HW failure?

Did you remove the api-port and api-allow settings? I imagine removing 127.0.0.1 might break things. If all else fails, re-image your SD card and start over.

TrX

I remove the api-port, this is not solved the my problem.
Where can I download the Cube SD card image?

I had a very similar problem with connection refused after I deleted their default pools and added mine. I use suprnova and wasn't sure what port to use. Suprnova does not mention port 9995 for this but it does say 80 and 443. I tried 80 but it didn't work maybe because everything was already screwed up by then so I just left the 9995 alone after recycled power. I recycled The miner since it would always say starting and no pools were showing up. When I powered the unit off and on and everything that was initially there appeared again and the miner started up OK after the power recycle. I just changed the suprnova config to use my account and been fine ever since.