Quote from: toptek on May 28, 2017, 08:48:08 PM

in the claymore.stub.conf are these lines below:

uncomment and configure the -dpool and -dwal lines below to enable dualmining.

Then go to the local.conf in the home Directly and put in your pool and wallet for the ETH miner, if your using the local.conf, I think i haven't really look into setting up dual mining yet with Ethos.

I have only learned to use the local.conf and claymore.stub conf's for eth and Zec mining .. haven't tried the remote or custom conf's .no need to,yet.!!!

I have EthOS running on two rigs .

claymore.stub.conf

# WARNING! Remove "#" characters to enable lines, with "#" they are disabled and will be ignored by miner! Check README for details.
# WARNING! Miner loads options from this file only if there are not any options in the command line!
-colors 1
-dbg -1
-esm STRATUMTYPE
-epool POOL1
-ewal WALLET
-epsw PASSWORD1
-eworker WORKER
-allpools 1
-gser 2
-allcoins 1
-wd 0

#uncomment and configure the -dpool and -dwal lines below to enable dualmining.
-mode 0

#-ewal 0xD69af2A796A737A103F12d2f0BCC563a13900E6F
#-epsw x
#-dpool stratum+tcp://yiimp.ccminer.org:4252
#-dwal DsUt9QagrYLvSkJHXCvhfiZHKafVtzd7Sq4
#-dpsw x
#-esm 1
#-mode 0
#-tt 70

then go to the local.conf in the same directly as the claymore.stub.conf and put in your pool and wallet for eth mining,you can leave the flags how they are for default setting, it didn't seem to matter if they are there or not .. if your using the local.conf, which is all i have learned to use.

some thing like below

local.conf

globalminer claymore
maxgputemp 85
stratumproxy enabled
proxywallet your wallet for eth
proxypool1 the pool you are using for eth mining.
globalfan 85
flags -logfile noappend.txt
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
I put the -logfile noappend.txt line in,because i don't like a lot of log files every time, i reboot or restart the miner it would make one, other wise that line is not needed, and all it does is over write the old log and replace it with a new log from the session running instead of making a new one for each restart ..

Just got it working! What you said to do worked, however you also have to specify what coin you are mining. To do this, simply add -dcoin somewhere in claymore.stub.conf followed by the coin you want to mine, sc for SIA.