Quote from: scryed on June 03, 2017, 12:14:48 AM

Quote from: minerx117 on June 02, 2017, 11:48:31 PM

Quote from: scryed on June 02, 2017, 12:21:35 AM

I'm having problems with the Alexis78 miner. Have you had this problem where the command prompt would lock up, gpu power would go down to 0% and it would stop mining until you hit the "enter" key? It happens every 30-60mins and it's really preventing me from using zpool.
Am I overclocking too much? The screenshot attached has it locked up and I didn't hit the "enter" key until 2 minutes later.

This is when I'm only mining skein with no algo switching.

http://imgur.com/jSX3MvH
http://imgur.com/EpdS7Ux

no i have never had that problem in 3+years of using ccminer never had it hang and have to press enter to get it going.. didn't even know that was possible... something must be wrong with your rig/drivers..

Yeah it's the strangest thing. Reducing everything to stock clock and 80% power limit pretty much solved the problem. It was happening more on zpool than mph. It seems to be very sensitive to overclocks. It's mostly resolved now.

My system:
Win 10
Biostar z170 GT7
Pentium G4400
4GB RAM
x1 1080 ti
x2 1070
x1 1060
EVGA GQ 850W PSU

Showing 600W at the wall. It never went past 600W even during OC.

nice mix of gpu's there.. all my rigs all run the same gpu's either 1060's or 1070's and i don't mismatch im not sure if thats why your having problem try a fresh install of latest nvidia driver should be the same driver for all those gpus Version: 382.33 WHQL(clean install) i run 6x1070 on a evga g2 1000 and 5x1060 on evga t2 750 so you should be fine...