Quote from: chup on June 04, 2017, 05:35:41 AM

Quote from: lazyturtle on June 03, 2017, 09:40:54 PM

Hello everyone. I have a problem with one of my rigs.

I get the ""WATCHDOG: GPU 0 hangs in OpenCL call, exit" problem after about 20-60 min running the claymore miner. It started tough with that my miner was loosing internet connection after running a while. When i fixed that by installing new network adapter drivers, the connection was stable but the GPU´s started to give 0.00 mh´s after a while, until getting the error message.

I did overclock the rig in the beggining, but i have reseted the MSI afterburner settings to default and i also did a bios mod, but i flashed the cards back to the original bios. I also dont think that the bios mod was the problem, because i have 3 more rigs with rx 470 with the same mod, and they all work great.

Specs:
Intel Celeron G1840 Processor
Asrock H81 Pro BTC motherboard
6x AMD Radeon RX 470 4GB
4GB DDR3 Memory
60GB SDD Harddisk
1000W Gold power supply
Windows 10 operating system

I have already tried to:
- Run the miner with the gser and eser commands and have also tried both dual and solo mining(both have same problems).
- fresh install of both operating system and Gpu drivers (first gpu drivers with DDU and after that operating system).
- Checked every riser, but they all work on a diffrent system so thats not the problem.
- Setting virtual memory to atleast 16000
- Tried old claymore miners, from 6.3 and up, same problem.

I dont really know what to do at this point, would really appreciate help if someone knows what might be causing this.

I believe with 60GB drive You don't have 20 GB virtual memory, right?

If you are mining with multiple GPUs you must set a virtual memory of a minimum of 16GB or the miner will likely crash.