Quote from: edop2005 on June 20, 2017, 05:13:27 AM

Quote from: jackbox on June 20, 2017, 01:21:41 AM

Quote from: edop2005 on June 20, 2017, 01:19:27 AM

Dualmining ETH/SIA on nanopool doesn't work for me. ETH works fine but SC gets job timeouts.

---------------------------------------------------------------------------------
ETH: 06/20/17-10:15:39 - New job from eth-eu1.nanopool.org:9999
ETH - Total Speed: 20.727 Mh/s, Total Shares: 5, Rejected: 0, Time: 00:18
ETH: GPU0 20.727 Mh/s
SC - Total Speed: 0.000 Mh/s, Total Shares: 0, Rejected: 0
SC: GPU0 0.000 Mh/s
GPU0 t=67C fan=0%
Socket was closed remotely (by pool)
SC: Job timeout, disconnect, retry in 20 sec...
---------------------------------------------------------------------------------

I used nanopool's autoconfig generator, here s my config

EthDcrMiner64.exe -epool eth-eu1.nanopool.org:9999 -ewal 0xmyethwallet -epsw x -dcoin sia -dpool sia-eu1.nanopool.org:7777 -dwal mysiawallet -dpsw x -ftime 10

Am I the only one? I tried replacing -dcoin sia with -dcoin sc but same result.

Did you change "0xmyethwallet" and "mysiawallet" to your actual wallet addresses?

Yes I replaced both. ETH is mining normally but I only get timeouts for sia. Can you paste your start.bat file? I ll try it and see it it works. Maybe there s something wrong with my SIA address?

I am having timeouts on sia as well both with nanapool and siamining.com. I was using SMOS and switched to Win10 but same thing happens. This time I got openCL call hang error and both ETH and SIA mining stopped as the miner crashed. At least it was mining ETH even if it get disconnected from sia pool.

I believe problem is bios mod/undervolt. Maybe I undervolted the gpu a bit more and extra load on dul minining crashes the card so the miner.

I will give some more juice but so far letting miner run to verify the gpu that has a problem.