I just got around to test v16.
Same error messages like below.
Getting infinite loop.
LCD connected to mobo graphics (like always in v15 and BIOS set to on board graphics not PCI)
Will test on PCI graphics later thi PM - hopefully no more infinite loops - will post results later.
Much better boot-up speed, this time can use USB3 port fully compatible with build?
I just added 5 more 20A circuits in my warehouse - fun times begins!
I can't seem to get v16 to work on tb-250.
It boots up then terminal pops up and says:
dos2unix: converting file /media/m1/1263-A96E/onebash to unix format
xorg problem detected
restarting xorg
rebooting in 5
Have tried different USB's and also booting with only one card but still have the same problem.
Anyone know what the problem might be?
Have you waited for the second boot?
If you are using one GPU it is expected that oneBash will need to rebuild the xorg file and reboot before OC will work as intended.
It should work without rebooting on the second boot; unless you have connected the monitor directly to the motherboard (always connect a monitor to the primary GPU).
I have had one member report that their rig is caught in an infinite loop of reboots; so I would like to know if this is happening to you as well.
Hi, you should NOT connect your monitor to the onboard graphics! That wil ruin the xorg.conf, so please move it to the primary PCI card. The new V0016 is checking your xorg.conf, correcting these issues, so after moving to the PCI card, you will have one more reboot and after that it should work.