I just got around to test v16.
Same error messages like below.
Getting infinite loop.
LCD connected to mobo graphics (like always in v15 and BIOS set to on board graphics not PCI)
Will test on PCI graphics later thi PM - hopefully no more infinite loops - will post results later.
Much better boot-up speed, this time can use USB3 port fully compatible with build?
I just added 5 more 20A circuits in my warehouse - fun times begins!
Have you waited for the second boot?
If you are using one GPU it is expected that oneBash will need to rebuild the xorg file and reboot before OC will work as intended.
It should work without rebooting on the second boot; unless you have connected the monitor directly to the motherboard (always connect a monitor to the primary GPU).
I have had one member report that their rig is caught in an infinite loop of reboots; so I would like to know if this is happening to you as well.
Same error messages like below.
Getting infinite loop.
LCD connected to mobo graphics (like always in v15 and BIOS set to on board graphics not PCI)
Will test on PCI graphics later thi PM - hopefully no more infinite loops - will post results later.
Much better boot-up speed, this time can use USB3 port fully compatible with build?
I just added 5 more 20A circuits in my warehouse - fun times begins!
I can't seem to get v16 to work on tb-250.
It boots up then terminal pops up and says:
Have tried different USB's and also booting with only one card but still have the same problem.
Anyone know what the problem might be?
It boots up then terminal pops up and says:
Quote
dos2unix: converting file /media/m1/1263-A96E/onebash to unix format
xorg problem detected
restarting xorg
rebooting in 5
xorg problem detected
restarting xorg
rebooting in 5
Have tried different USB's and also booting with only one card but still have the same problem.
Anyone know what the problem might be?
Have you waited for the second boot?
If you are using one GPU it is expected that oneBash will need to rebuild the xorg file and reboot before OC will work as intended.
It should work without rebooting on the second boot; unless you have connected the monitor directly to the motherboard (always connect a monitor to the primary GPU).
I have had one member report that their rig is caught in an infinite loop of reboots; so I would like to know if this is happening to you as well.
Full Zero was right. If you change your primary display to PCI and plug your monitor into your primary card it will boot.
The other great thing is my clocks are working with v16...my 1070's have gone from 390MH to 430 MH
Thanks full zero!!