Quote from: VentMine on July 20, 2017, 02:10:10 AM

Quote from: NotFuzzyWarm on July 19, 2017, 10:40:01 PM

Quote from: edonkey on July 19, 2017, 07:36:54 PM

...
If you put in bad URLs for your pools you can fire up a unit and the fans will run, albeit at a somewhat lower speed, without hashing.

I use a similar technique in reverse to cool my Antminers before shutting them down. Specifically, I change the pool URLs to something wrong (by adding an 'x' character to the domain, for example) then hit "Save & Apply". The result is the miner software restarts, but can't get work from any pools, so the fans run without the boards doing any real work. After a few minutes the output from the fans is significantly cooler.

I have to admit that I don't know if cooling them down before powering them off provides any actual value. But with the insane amount of BTUs these suckers pump out it feels like just shutting them off while hot is not a great idea.

Me likey that trick! Methinks I will add that as a custom command sequence in Awesome Miner for when I do have to turn them off for cleaning and such. Cheesy

Yes you are right, simple powering down does result in a rather significant temp spike in the miners for at least a minute or more.

It might not start hashing with a wrong URL but is there still a risk of short circuit due to condensation? Seems risky to try.. but thanks for the idea!

I'm guessing there's no way to modify the firmware?

The thing is, my source of power is a natural gas genset and I do not have grid power even close. So a back-up heater would have to be propane or natural gas fueled, which tends to give off moisture itself if it's the catalytic variety. I can probably get a wall mounted NG heater that vents to the exterior and avoid the moisture issue...

u can also get a dehumidifier that runs in there but only if its a sealed location like a house or office since it would run non stop in an unsealed location.