Quote from: SummersideGuy on July 21, 2017, 03:28:00 AM

Quote from: iam1000fold on July 21, 2017, 02:18:23 AM

Quote from: SummersideGuy on July 21, 2017, 02:09:32 AM

Quote from: iam1000fold on July 21, 2017, 01:59:35 AM

Hi guys! I'm just new in crypto mining and started with a 4-GPU set for my rig. I don't have anything to pay you in exchange for a little help or reply but maybe somehow someone could share their knowledge concerning my setup, and it would be greatly appreciated.

My gpu is a HIS RX560 (Hynix) 4GB OC. I already tried to mod it one by one by copying the 1:1750 timing to 1:1875 to 2000 and 2:1750 all the way to 2:2200 and overclocked it core: 1250 and memory:2000 with +10 power. I managed to get 11.2mH/s in ETH claymore mining. I also tried other settings but that's the best i could get.

Here's my problem:
1.) whenever i plug-in the hdmi connector to the built-in (on-board) gpu...my mod setting in afterburner will not worked...everything is just 0...you cannot change the core, mem...everything...but all my 4 gpus were detected and it runs in its stock hashrate of 10mH.

2.)afterburner will only work if i connect the hdmi to one of the 4 gpu and then i could change the settings but only one gpu will only change in terms of hashrate, wherein i could get around 11.2mH while the other 3 gpu runs in its stock hashrate of 10mH.

any advice? what's wrong with my setup/mod? please could someone help me on this.

i will be posting my moddedROM if someone would like to test it.

thanks in advance!

Did you run atikmdag-patcher-1.4.5 after you modded your bios. Also your card have Hyniz so you should use 1:1500 and 2:1500. I have only played around with a 570 so far but it has Hynix 4GB same as yoru 560's and I have it to 28.3 vs 22 it was at stock. I have some 560s coming in next week so will know better then about those

thanks for the quick reply SummersideGuy...yeah i did run the patcher once...it worked only for one gpu...the one connected to the hdmi where i manage to get 11mH...and i tried to do it again but it just ask me to revert to the default driver/setting...

I will know more once my 4 560s come in and I can experiment with them to see what you are experiencing. The 570 I have now is not hooked t my Monitor and it was the normal routine - Backup bios. modify bios, reboot, run patcher, reboot, good to go. I know from everything I read for Hynix to use line 1500 in your timings. It pushed my 570 up pretty high. I am hoping to get 14+ with the 560s when they get here. Not sure what memory they will have the are Asus Rog Strix models 4GB models. Once I have them and play around i will be able to assist you better

Thanks a lot...i will be waiting for that...i'll try to upload my gpu rom (the original one and the one that i modified) later when i got home. Again thanks for the time. I really appreciate it.