Quote from: WoolF911 on July 21, 2017, 11:15:03 PM

Quote from: fullzero on July 21, 2017, 10:35:45 PM

What is

Code:

COIN="ZEC"

set to?

Also

What kind of USB key or SSD are you using?

Depending on if you have:

Code:

COIN="X"

where X is one of the following:

DMD GRS ZPOOL_LYRA2V2 ZPOOL_BLAKE2S
ZEC ZCOIN HUSH ZEN ZCL
NICE_ETHASH ETH MUSIC ETC EXP DCR PASC
MONA VTC DGB SIA FTC LBC
DUAL_ETC_DCR DUAL_ETC_PASC DUAL_ETC_LBC DUAL_ETC_SC
DUAL_EXP_DCR DUAL_EXP_PASC DUAL_EXP_LBC DUAL_EXP_SC
DUAL_ETH_DCR DUAL_ETH_PASC DUAL_ETH_LBC DUAL_ETH_SC
DUAL_MUSIC_DCR DUAL_MUSIC_PASC DUAL_MUSIC_LBC DUAL_MUSIC_SC

If you do; then

I would try re imaging / adding updated 1bash and files.

Also I have the error "Utilization is too low: restart 1bash" and multiple "Maxximus007_AUTO_TEMPERATURE_CONTROL" tabs. What it's mean? Maybe this is a reason of problem?

Code:

ZEC_WORKER="nv$IP_AS_WORKER"
ZEC_ADDRESS="t1fs7FDSwQPayfp9B95NNw5LKLdqnfuTEcF"
ZEC_POOL="zec-ru1.dwarfpool.com"
ZEC_PORT="3337"

EWBF_VERSION="3_4" # choose 3_3 or 3_4

I'm trying to change COIN="ZEC" to COIN="ZCL", but I still have 0-50 Sol/s.

I'm using Intenso Ultra Line USB3.0 32GB.

I trying to add 1bash and files again, but result is same.

I would change

Code:

ZEC_PORT="3337"

to

Code:

ZEC_PORT="3333"

But your ZEC config looks like it should work with DwarfPool.

It is also worth trying removing the workername:

Code:

ZEC_WORKER="nv$IP_AS_WORKER"

to

Code:

ZEC_WORKER=""

With:

Also I have the error "Utilization is too low: restart 1bash" and multiple "Maxximus007_AUTO_TEMPERATURE_CONTROL" tabs. What it's mean? Maybe this is a reason of problem?

Due to some changes I made in the last 1bash; currently when in LOCAL mode: each restart of 1bash will kill the existing Maxximus007_AUTO_TEMPERATURE_CONTROL process, but not kill the tab containing it; then a new Maxximus007_AUTO_TEMPERATURE_CONTROL tab will be created with a new process inside.

The problem is likely that you are not connecting to the pool for some reason; when this happens the watchdog will detect low utilization and restart 1bash.

You can see if you can reach the pool by opening a new guake tab and entering the following cmd:

Code:

ping zec-ru1.dwarfpool.com

I would try to use a different pool and see if you can connect. For now while troubleshooting; I would set :

Code:

IAmNotAJeep_and_Maxximus007_WATCHDOG="NO"