Quote from: WoolF911 on July 22, 2017, 05:09:22 AM

Quote from: fullzero on July 22, 2017, 02:44:35 AM

I would change

Code:

ZEC_PORT="3337"

to

Code:

ZEC_PORT="3333"

But your ZEC config looks like it should work with DwarfPool.

It is also worth trying removing the workername:

Code:

ZEC_WORKER="nv$IP_AS_WORKER"

to

Code:

ZEC_WORKER=""

With:

Also I have the error "Utilization is too low: restart 1bash" and multiple "Maxximus007_AUTO_TEMPERATURE_CONTROL" tabs. What it's mean? Maybe this is a reason of problem?

Due to some changes I made in the last 1bash; currently when in LOCAL mode: each restart of 1bash will kill the existing Maxximus007_AUTO_TEMPERATURE_CONTROL process, but not kill the tab containing it; then a new Maxximus007_AUTO_TEMPERATURE_CONTROL tab will be created with a new process inside.

The problem is likely that you are not connecting to the pool for some reason; when this happens the watchdog will detect low utilization and restart 1bash.

You can see if you can reach the pool by opening a new guake tab and entering the following cmd:

Code:

ping zec-ru1.dwarfpool.com

I would try to use a different pool and see if you can connect. For now while troubleshooting; I would set :

Code:

IAmNotAJeep_and_Maxximus007_WATCHDOG="NO"

fullzero, thank you for your reply. I'm sure that is no problem with connection to the pool, also ping is ok. I think it's a some problem with powerlimit, because when I disabled watchdog and trying to change some parameters, include powerlimit, my hashrate is growing to 200 Sol/s, also when I changed some parameters I seen my hashrate grow to 400 Sol/s, but I don't remember parameters what I changed. So at this moment I have hashrate 200 Sol/s with powerlimit 200, when I trying to change it to 250 I have lower hashrate. Cc 150, mc 900 as you wrote in the first message here. Also console showed power consumption lower than I set powerlimit. Any idea?

If you are using the Maxximus007_AUTO_TEMPERATURE_CONTROL ensure you are also changing the individual powerlimits for each GPU:

Code:

INDIVIDUAL_POWERLIMIT_0=75

INDIVIDUAL_POWERLIMIT_1=75

INDIVIDUAL_POWERLIMIT_2=75

for a 1080ti I recommend using between a 200 and 225 powerlimit.

If you have already done this:

It is also possible there are some bad sectors on your USB key and they are causing problems. I have had 5x USB keys go bad so far; although I do reimage a lot with test rigs.

It might be a good idea to try using another USB key or SSD.