Quote from: philwmich on July 31, 2017, 12:11:41 AM

Hey everyone, new miner here. I am at a month long training course, stuck in a hotel. I have always been intrigued with mining and I have been very bored so I put a small starter rig together. I am not getting the hash rate that I believe I should be though. I am running the claymore dual miner, mining Ubiq and Sia. I am using Gigabyte GTX 1060 3G dual fan cards. I have played with the OC setting a bit on afterburner, but the highest I can get is around 18Mh/s. I have seen other people on youtube report 22 or 23 out of this card. If I overclock the core much the screen will turn black after a minute. If I OC the memory I get artifacts. I have seen some people run with the memory clock maxed out though, and mine won't do that.

Does anyone else use a 1060? What are your afterburner settings?

Thanks!

Hi Phil. I mine with 6x PNY GTX 1060 3gb cards. I get 23.5mh/s Eth and 180 mh/s SC per card. Once I run the Claymore 9.7 dual miner (make sure you use this updated version), I press the "-" key until it gets to 23. This controls how much hash goes to each coin and 23 is what I found works best for me because I wanted to focus on Eth.

My Afterburner settings are:
65% Power
Temp at 67 degrees (I have a box fan next to rig and it never goes above 57 degrees)
Auto fans
748 memory
20 core clock

The memory is the most important. I found the core clock adds little to nothing but if you go over 125 core clock you will crash alot. My rig runs stable, it never crashes.