Quote from: commax on August 01, 2017, 12:26:48 PM

Quote from: chrysophylax on August 01, 2017, 07:55:02 AM

Quote from: commax on August 01, 2017, 06:25:31 AM

Quote from: chrysophylax on August 01, 2017, 05:20:02 AM

Quote from: zorvalth on August 01, 2017, 05:06:52 AM

Quote from: chrysophylax on August 01, 2017, 03:20:07 AM

Quote from: commax on July 31, 2017, 10:26:32 PM

My rig has 6 pcs of 1080 , hash rate about 221 MH/s.

It alway connect to port 6000, that is for hi-diff.

Do I need to change to port 2000 , lo-diff? and How?

if you are using the current CWIgm-0.9.7 - this is not possible ...

the current miner is locked to lodiff port 2000 ...

this will change as we will add a port parameter for you to choose in the next small update ...

the diff was a little too high a target for the lodiff stratum port - thats changed now - and will not hit higher than 2.5diff ...

port 6000 however - starts at that diff ... and can handle all the hash you can throw at it ...

#crysx

Mine always connect to 6000:

thats strange ...

the reason i say that is simply because we did not activate the autosense feature in the miner ...

or should i say - we were NOT SUPPOSED to activate it ... not yet anyway ...

is everyone having this same issue? ... if so - then we must have set it active last codebase ... it shouldnt have been active until the next revision - as its currently experimental ...

with this next version - the autosense ( CWISense ) module will still be active - BUT you will be able to manually the port ... this will be released very soon ... though like i mentioned earlier - all those that have a miner currently will need to upgrade - and the system ( or lack thereof ) we currently have will take a while before we get everyone with the new miner ...

bear with us as we figure out how to get all those in our beta test the new miner ...

possibly an email address? ... will be checking if mega has this option ...

#crysx

Mine always connect to port 6000 , too.

yup ...

i see - and also notice that you have 6cards ...

the autosense mechanism sees more than 6gpu - and autoswitches to the higher port ...

like i mentioned earlier - this is an experimental feature and you will be able to over ride this in the new version ...

tanx for bringing this to our attention ...

#crysx

That is my second rig , 7 pcs of 1070.

This is my first rig , 6 pcs of 1080. always connect to port 6000 , too.

yup ...

and thats because anything above four gpu is automatically redirected to port 6000 ... we found it ...

in the next version - you override that autosense option with the port you wish to mine at - manually ...

have some patience - as we are preparing the next version to send ... its updated - but we need a better way of informing the beta testers than the current way ... CWIgm-0.9.7.1 is the next version - packed and ready to go ... now - we need everyone in the beta test to upgrade - and all those that wish to test need to be part of the list also ...

we are looking at how to do this now with mega / one drive ...

which means you will need to register / supply credentials to get the link for the miner ...

we will hopefully have this done in the next 24hours ...

tanx ...

#crysx