Quote from: fullzero on August 23, 2017, 04:05:04 AM

Quote from: ivoldemar on August 22, 2017, 10:38:40 AM

Quote from: cryptolover1981 on August 21, 2017, 10:15:32 PM

P106-100 BOUNTY

The person who will be able to unlock the overclock of my 13x P106 Rig (on the ASRock H110 BTC) with nvOC will get

1 ETH

I only got pure P106-rigs and no non-mining cards mixtures.

PM me and I will give you access to one of my Rigs.

Thanks!

I'm ready to make a donation too, if the issue with P106 cards is finally solved, but it's been so long already ...

Download the pure P106-100 1bash for headless SSH operation from the link on the OP; replace the 1 bash on your rig with it.

Add your pool / addresses / workername to the 1bash.

Note: for this version don't use:

Maxximus007_AUTO_TEMPERATURE_CONTROL

or

IAmNotAJeep_and_Maxximus007_WATCHDOG

ensure they are both set to "NO"

Run the mining process; it should not OC at this time. This is expected; it will alter the xorg.conf as needed.

Note the Rig IP; write it down.

If you are not already running fully headless; ensure that you reboot: disconnecting any monitor from integrated graphics on the mobo before the rig reboots.

With your rig IP ssh into the rig after it boots ( see guide on the OP for more information on how to do this. If from a linux system use the cmd from terminal:

Code:

ssh m1@your_rig_ip_here

you will be prompted

enter:

Code:

yes

the password is:

Code:

miner1

once you are logged in via SSH; enter:

Code:

screen -ls

if there is already a screen named miner use the cmd:

Code:

screen -r miner

to reconnect to the mining process and ignore the rest of this guide

if there is not; enter the cmd:

Code:

bash 1bash

to launch the mining process

once you see the message:

Quote

process in screen miner; attach with: screen -r miner

hit

Code:

ctrl + c

then enter:

Code:

screen -r miner

If you have problems with this; let me know. I can't test this directly as I don't have these GPUs; but this should work unless I made a typo in the 1bash.

Also; you can edit the 1bash via SSH with the cmd:

Code:

nano 1bash

note this is a visual editor; again see the SSH guide for more info on nano.

Thank you so much for the quick respond. I'm getting GPU 0, GpuMiner cu_k1 failed 77, an illegal memory access was encountered in claymore and CUDA failure 77: an illegal memory access was encountered ; in Genoil, after a few seconds of mining.

Also in ZEC it says CUDA: Device: 3 Thread exited with code: 77
or CUDA: Device: 3 Thread exited with code: 64

Am I doing something wrong?

I will make a donation for your lovely p106 1bash.

best regards