Quote from: fullzero on September 02, 2017, 06:19:42 PM

Quote from: gs777 on September 01, 2017, 07:27:51 PM

Quote from: JudoFlash on September 01, 2017, 02:27:04 AM

Quote from: Doftorul on September 01, 2017, 01:27:26 AM

Hi there nvoc-ers !

I may be stupid or definitely not paying enough attention to something as i can't for sake of me to be able to make AsRock H110 to recognize 13 x 1060 6GB GPU's. Tried with nvoc17, then 18, then 19..does not see the gpu on the last pciex slot.
It mines beautifully with 12 GPU's but there is no way i can make it see all the 13 GPU's.
The rig is built using a G4560, i tried using an i3... same result.
2 x Corsair 1000 W PSU's powering 6 gpu + mobo + risers and the 2nd powering 7 gpu's

Any hints ?

I struggled with this for a very long time. For me, it came down to a bad riser. I could have sworn I had tested and replaced them all, but this past weekend I started with one, and kept adding 1, one boot at a time, until I got to 13 working. I swear I did this a few times, but i find the pic-e risers LOVED to come loose as well, and may have had bad luck swapping a bad riser for a bad riser.

Aside from that, if you haven't, I would make sure the the 2 molex connectors on the motherboard are each connected to the separate power supplies.

Also, I noticed you have all risers on one PSU. I believe I have read that you should not have more than 2 per connector - I am unsure how many connectors are on those corsairs, but it might be worth trying splitting them up if you haven't.

Let me know if you get anywhere with this.

I put 3 risers per 1 connector - works fine

Depends on the GPU; 3 risers per 1 connector with AM 1080tis is unstable.

Yeah I had 3 1080ti risers connected to a single connector (ran for about ~2 months) with 0 issues but saw some melted cables pictures on this forum and changed them out immediately