Quote from: MauiDave on September 09, 2017, 10:36:02 PM

Hi all,

Just bought a used Antminer S7. I was told it probably has a bad board, but he wasn't sure and didn't want to deal with it. For the price, it was worth buying and fixing.

Just set it up, starts up, I can see it on the network and can access the HTML setup page just fine.

So, the red light stays on and it starts beeping after a while. I have one fan running.

In the "Miner Status", the hash rate is 0. I don't see any numbers for the fan, however when I was troubleshooting the other night, I hooked up the fans from one of my S9's and it did see them. The fan I'm using now, I bought from a dealer who says they're totally for Antminers, guaranteed. Not sure, but either way, I don't think THAT would cause the beeping and 0 hash.

So, looking for some help, someone who is knowledgeable and willing to troubleshoot this with me. I will pay for your time if you're an efficient troubleshooter.

email me directly at dave@filmsound.com as well as responding here.

Thanks

I would double check your miner pool config. Without connectivity to the pool, you will get the red light beep.