Quote from: NewbieMiner17 on September 12, 2017, 07:28:59 AM

Quote from: nsomnia on September 11, 2017, 05:20:31 PM

Quote from: NewbieMiner17 on September 11, 2017, 09:56:18 AM

Hey guys my first post here!

1) Is it safe to run at this temperature or should I stop it until I get a fix?
2) How can I have claymore display the correct temperatures (is it the anorak bios that is affecting it?)

My r9 290x runs at 91-94 all day long. My rx 460 bios modded at 60-69 and my 1060 3gb at 57-60 when not dual mining (are any coins profitable to dual mine at 30% intensity and easy to save in a wallet/exchange? I tried zpool but my balance is still 0.0 after a full day running it.

You need to install the blockchain drivers and then the temps will show up OR buy/build an hdmi dummy plug and it will report them. If you can open WattMan you can see temps on Claymores however I dont need my dummy plugs anymore after putting the modded bios in and upgrading to v10.

Temps:
GPU0: 82 C (FAN: 62%)
GPU1: 59 C (FAN: 52%)
GPU2: 54 C (FAN: 100%)

Hey man thanks for your feedback seems to have been lost in all the other Vega chat apart from you and Ursul0

So I found the problem on the reporting of temperatures and it was due to Claymore V9.7. After updating all that I was getting the reporting numbers ok and my -tt and -ttli etc seem to have started working

Now I'm running at a steady 25MH ETH and 750 Sia with temperatures of around 65C for most cards and 40-50% fan with one card running a bit hotter at ~75 and 60-70% fan. Not exactly sure why that is happening but will keep tinkering until I find it... Think it is the second card in and it might be taking heat from first card as well as any heat generated from PSU which is pushed on (will check this by moving PSU away when I have time to run prolonged tests).

So now a few more questions:
1) Should I be happy with 25MH or should I push for 28 on these RX480 Shaphire Nitro+ 4GB(Elpida)? If so how do I do it? I currently have the Anorak Memshift Bios installed (when I had the overclocked Bios it tipped my PSU over 1200 when it tried dual mining). Would I need to go back to standard bios before trying any mods through claymore? What should be starting point and where should I be expected to get to?
2) Does anyone else have problems with their USB Risers? Mine every so often come slightly loose (think USB cable moving it) and it causes a crash. Thinking of putting cable clips on the frame to stop the cable from moving freely between GPU and risers but wondering if actually required.

Thanks

Is that in Fahrenheit? 91 is pretty high for celcius. I think you can cook an egg on there Cheesy