Quote from: os2sam on June 21, 2013, 02:16:12 AM

Quote from: Trance104 on June 21, 2013, 02:12:12 AM

How do I use CGminer to ONLY mine using my ASIC? I have block eruptors plugged in and I get an INSANE error log while my Jalapeno, and 2 GPU's are mining. I want it to STOP mining using my GPU's and STOP trying to connect to the Block eruptors.

Use CGMiner-nogpu.

Block Erupters are ASIC's too. If they are getting errors try putting some fans on them and use the WinUSB driver like it says.

If you don't want to use the Block Erupters then unplug them from your USB ports.

Quote from: daemondazz on June 21, 2013, 02:37:43 AM

Quote from: Trance104 on June 21, 2013, 02:26:37 AM

I'd like to use them, but with a different client. How can I do this?

Use a second PC?

OR you could search / read the thread / read the manual instead of reposting questions...

Quote from: os2sam on June 12, 2013, 11:51:33 AM

Quote from: ckolivas on June 12, 2013, 11:26:17 AM

Quote from: os2sam on June 12, 2013, 11:05:59 AM

I'm trying to disable two AMU's, out of 4 total, in each CGMiner session.

"-d 0 -d 1 --remove-disabled" in the first session works fine.
"-d 2 -d 3 --remove-disabled" in the second session does not work.

when I run CGMiner-nogpu -n it says "failed to open, err -3"

It appears that you intend for CGMiner to be able to do this and I would like to run two sessions for two different pools.
Thanks,
Sam

The --usb command gives you finer control over this. The --device command only takes one set of values now (-d 0-1 instead of -d 0 -d 1) and only works for usb devices since version 3.2.1, and it is a coarse command.

Ah, in other words RTFM

. I found the section in the readme and I'll give it a whirl tonight.
Thanks,
Sam