Quote from: mohicans on November 17, 2017, 03:18:49 AM

Quote from: blissz on November 16, 2017, 05:25:16 PM

Instructions:
set the miner frequency at 400mhz and set your fan speed at 25% before flashing. After flashing, check the advanced settings page and start at the lowest voltage setting. From there increase your frequency to see how high you can go at the lowest voltage setting.

the fan is at 25%.. does it means 25% run on initial startup to eliminate the max rpm during startup?
What is the fan speed when at full hashing operation? remain at 25% or increases accordingly to running temperature?

p/s I am from a hot climate country..and running with natural air ventilation without AC

during startup it's fixed to 10% fan speed now. The percentage you give in is the speed at full hashing operation.