Quote from: blissz on November 21, 2017, 07:46:19 PM

Quote from: acyclovir on November 21, 2017, 07:40:30 PM

Hi Blissz, could you please explain me why when running a D3 with your mod, at 220v triphase (500 Mhz in both cases, at 10th level Volt global) I get more AMP consumption (mesured with ammeter)

Your mod gives 5 AMP at 500Mhz, level 10 global
Default Bitmain's 4.6 AMP at 500MHZ

As far as i have read, A= W/V, so W=A*V? then, in my particular case, consumption should be higer with your mod or am i wrong?

Which batch you have and what AMP meter do you use?
Actually I found out that voltage setting "13" is the bitmain's default voltage for the October batch, so it's strange that you're seeing more amps on setting 10 actually.

The things you can try:
1) Can you try to lower the voltage setting (ie to Cool

to get upto 4.6 AMP or do you see HW errors if you do so?
2) set the FAN to a static value (ie 50%) and check the chip temperatures to compare. Chip temps will give a good indication of the wattage being used.

What could be the relaton betwen Chip temp/wattage?

October batch at 537 Mhz default, before flashing your mod i have lowered my 3 D3 to 500 Mhz because had a lot of HW, indeed, flashing and tweaking with your mod, i haven't be able to correct the HW. Furthermore, the lowest temp of the chips i have had, is 87-89º at 28º ambient, mine are too hot, i wil take a pic of the ammeter tomorrow, is the one of a clamp to test by cable, i have Bitmain's PSU in each one, at 220v, please a little patience with my poor english, thanks