Quote from: logicassets on November 23, 2017, 01:37:19 PM

For Eth-only, -dcri does nothing unless you are using -asm. From Claymore:

-dcri Decred/Siacoin/Lbry/Pascal intensity, or Ethereum fine-tuning value in ETH-only ASM mode. Default value is 30, you can adjust this value to get the best Decred/Siacoin/Lbry mining speed without reducing Ethereum mining speed.
You can also specify values for every card, for example "-dcri 30,100,50".
You can change the intensity in runtime with "+" and "-" keys and check current statistics with "s" key.
For example, by default (-dcri 30) 390 card shows 29MH/s for Ethereum and 440MH/s for Decred. Setting -dcri 70 causes 24MH/s for Ethereum and 850MH/s for Decred.

-asm (AMD cards only) enables assembler GPU kernels. In this mode some tuning is required even in ETH-only mode, use "-dcri" option or or "+/-" keys in runtime to set best speed.
Currently ETH-LBRY mode is not supported in assembler.
Specify "-asm 0" to disable this option. You can also specify values for every card, for example "-asm 0,1,0". Default value is "1".
If ASM mode is enabled, miner must show "GPU #x: algorithm ASM" at startup.
Check "FINE-TUNING" section below for additional notes.
NEW: added alternative assembler kernels for Tonga and Polaris cards for ETH-only mode. Use them if you get best speed at "-dcri 1" (i.e. you cannot find speed peak), use "-asm 2" option to enable this mode.

Feel free to experiment. Results will vary. Wink

Quote from: NexusPrime on November 23, 2017, 11:22:04 AM

Quote from: logicassets on November 22, 2017, 11:15:12 PM

You parameter [-dcri 5] is for dual mining. A ~1mh per GPU difference from windows to Linux is normal. Your hashrate is fine.

Quote from: NexusPrime on November 22, 2017, 12:57:06 PM

Quote from: logicassets on November 22, 2017, 10:37:24 AM

29.66mhs (ETH) per RX470 when dual mining is as good as it gets. What's your hash on eth only?

Quote from: NexusPrime on November 22, 2017, 09:33:17 AM

Quote from: NexusPrime on November 21, 2017, 11:16:51 PM

hey guys im using this amazing simpleminning but im trying to get most of my rig so needed an advice for overclocing for fulll hashrate

i own 6 Saphire RX 470 8gb hynix memory

i managed to get it 178hash but is there possibility for more without any issue ofc.

my settings are

core mhz: 1150
mem mhz: 2150

Core Unvervolting: 900

powerstage 6

-epsw x -tstop 75 -dcri 5

any expert can help me out with this please

its same mate 180hash just when i started on simplemine it droped to 178hash

btw im minning only Ethereum Classic ETC atm no dual nothing

aha but im not dual minning when i use this dcri 5 it incresses the hashrate but should i remove it or use another number instead

aha i understand but what do you suggest me to set for my rig configurations