Quote from: thiec on November 28, 2017, 01:00:34 AM

Quote from: mrcinema on November 27, 2017, 12:53:57 PM

Could anyone urgently help please.

I have D3's plugged in, I've updated their Firmware to the latest on the Bitmain website and since then I keep getting this issue.
The chip statuses go to XXXXXX and hash 0.

I've tried reflashing it with the firmware again and doing a power down and on.
I appreciate any help, thanks!

https://s7.postimg.org/5i5efj7vv/bitmainhelp.png

Try to lower the freq and reboot your miner. I hope its works
Try to downgrade your firmware, i have notice that Nov firmware is not as good as previous one (sept/august)

I fixed that issue by resetting the machine by pressing the reset button, only inconvenience is that it resets the settings, but it does fix it as I think it loads the old firmware on it.

I seem to have another issue on the original firmware where after a little bit of time the chips will go to XXXX, but not all of them. (there is a o between some of the x's)

https://s7.postimg.org/3see852t7/bitm.jpg