Quote from: polyminer on November 30, 2017, 01:31:16 PM

Quote from: RealCrypto.org on November 29, 2017, 09:27:06 PM

Quote from: polyminer on November 29, 2017, 12:30:44 PM

Quote from: jizzy87 on November 29, 2017, 12:04:47 PM

new firmware is good fixed both my broken miners hashing at 33-35 ghs

Can you tell the sequence (steps) in which you did your update? I might be doing something wrong. Thanks.

Did you put the boot image on the SD card per their instructions? If you're on Mac use applePi Baker to put the OS on to the SD card. Download the firmware on to your computer. After you have both the firmware and the boot image, insert the mini sd card into the device and then upload the firmware at the same time. Once the firmware is done, you can turn off the device to then remove the sd card. turn it back on and put in your pool information to start mining.

1st - I did the web update with the update.bin but that didn't change anything. So...
2nd - did the boot.img update from sd-card. That change for the worst, can't overclock or stay at default setting cos miner will underperform and fan speed went to 90% even temp was stable @ 48c avg.
3rd - I've just tried your method, inserted the sd card + update on web at the same time, when web update finished, miner reboots into sd card, red light, then flashing green light. Waited 2min before turning off miner. Took out sd card. Turn on miner again. Same result. Have to underclock to 1000mhz/14vid to get stable 30.2ghs.

Sent screenshots to Innosilicon, waiting for support. Before this update, I was running @ 1200mhz/10vid/36.5ghs/48c avg/0.025DASH per day. However they said that the new update will increase stability of the miner and such, so I updated and voila... a miner which underperforms. I think this new firmware helped people who had problems in the first place but if you don't have any problem, don't update!

Hope they will issue fix soon or at least give us the possibility to go back to old version, but nope, they took down Dash_r1.0 firmware from their site.

I couldn't get this ASIC to be any faster than 32gh/s. Overclocking before and after the update only slowed down the hash rate. I am currently mining on default settings at a stable 32gh/s. I have been emailing them too and getting responses asking for more information. Once I get anything that can benefit you guys I'll post it here.