Quote from: Trofo on December 11, 2017, 09:51:15 PM

Quote from: Jaseofspades on December 11, 2017, 09:40:11 PM

Hi All,

I'm in this coin and excited about its prospects. Would it be possible to ask a proper Noob question to the group? Pls excuse me, I am not new to Crypto, but have never mined/staked etc.

Basically I followed the guide on page 68 to set up the minting operation through My Ether Wallet. It all seemed to go through fine and I have GWEI set at 21. When I put my ETH address in the POS Token calculator is says zero reward and zero token day, even though I've had them for a few weeks. Can anyone advise what I am doing wrong? Do I have to have my laptop on for 3 days straight before it works?

Sorry if the question is obvious, but any help on what I am doing wrong gratefully received. Thanks all and good luck to all holders. Cheers.

Jas

You mixed the steps. You should have first checked PoS Coin calculator to see amount of coins you can get trough minting. After successful minting calculator shows 0 for 3 days because you are able to mint again only after 3 days.

In the end it doesn't matter, you have received your due coins if you had them on your myeterwallet. The coins don't stake if they are on eterdelta for example. One more tip, always check your balance trough myeterwallet or etherdelta (visible immediately after transaction goes trough) because etherscan will show minted coins after significant delay(could be days).

Sorry bit late - but thanks for your help with this Trofo! Worked it out