Quote from: UrbanCryptoGuy on December 12, 2017, 02:49:38 AM

Quote from: East113 on December 12, 2017, 02:29:13 AM

So I'm currently running 1 of 3 1070ti's while I wait for my larger PSU to come in to run them all. I have a Gigabyte 270P-D3 mobo.

Mining ZEN I'm currently at 457 Sol/s on this one card. I know they can reach the 500 mark however no matter what I set the OC to it does not change. Have it set to 0/0 at the moment and it is doing the same rate as when it was 200/700. Power is set to 110 watts and the fan is 50% running around 65c.

It shows that the program is supposedly setting the OC settings but I'm unsure if the changes are actually happening as it does not seem to affect anything.

Any input as to what may be up with this?

I have a very similar setup, I'll share where I'm at after tweaking and following the advice of folks here.
I'm suggesting you change yours, just offering up what works for me in SimpleMiner.

Currently, I'm set to +200 core, +700 mem, 126w, 70 for temp, and 52% Fan Speed.
With that, I'm no averaging 510-515 Sols/s per card. I have three EVGA 1070 Ti FTW2's running on an EVGA 1000w SuperNova Platinum P2.
It's dead quiet and running perfectly between 57-40 Celsius per card.

I'll give those a shot when SMOS is back up and going. Maybe I just need to up the power? I'm running the same cards though. Also I wonder if it could be my current PSU? It's a 500w SFX psu from my other build that I had laying around, figured it would work for one card for now to get it up and running and the quirks knocked out.

I know these cards can handle 500 easy from everything I've read and seen so it's been a bit aggravating to be stuck at the 460 mark.

Def. love the silence though, I've had to check to make sure it's running!