Quote from: mkmfins on December 13, 2017, 02:15:56 AM

Quote from: Friday13 on December 12, 2017, 09:33:45 PM

Quote from: cryptonitro on December 12, 2017, 08:52:51 PM

Quote from: Friday13 on December 12, 2017, 08:49:02 PM

after running my two d3's with 400Mhz since 2 Days, im getting tousands of HW in a few hours.
i rised the voltage already to 2 but its dont getting better.
but it dont affects the hashrate or the asics, so can i keep it running or should i rise the voltage further?

try to set default voltage (13) to test then lower 2 by 2 to see ... whats your ambiant temp ?
if you have less than 12~15 hw / hour it s ok

yeah i rised the voltage to 3 and see what happens, if needed i go further.
my ambient temp.... they stay in a basement and i think its somewhere between 15 an 20°C and i placed a little vent in front of them
the chiptemps are between 64 and 72°C

Yeah.
I think next year she can become a great miner, but it's complicated. I spent a lot of money on an investment that was great, but it fell so deep that it totally discouraged. And now these defective badges have discouraged me even more ...

Now I do not know if I get that bad shit or if I wrap it up for them to fix.

The problem is that they never reply to me in the support, and when they respond, I just send CTRL + C and CTRL + V, it's complicated.

I will try to test the reset button you said ... It's a very small hole that stays in the machine right?

do a factory reset and re-flash the firmware again