Quote from: Fran78 on December 16, 2017, 01:19:29 PM

Hi,

I am pretty new in the mining world. From the Netherlands, so my English is a little poor perhaps.

This week we received 15 Baikal X10 miners. We already have L3's and Innosilicons running.
The interface for the Baikal is totally different, so i am having difficulty configuring that. But that is probably just practice and searching the internet. (however, tips are very welcome!)

But besides that, if have even a bigger problem. We now have 9 Baikals running. The other 6 i can't seem to find. I tried to look them up in Baikal scanner, and also in Advanced ip scanner, but no succes!

There is no reset buton on the miners. No sd slot. Only an USB slot and an other litte slot for some sort of connection cable. I read something about installing a new sd card image. Can i do this with usb aswell? There is no sd slot in the Baikal.

Again, 9 miners appeared perfectly when using ip scanner. But the other 6 are ghosts.....
I picked two of the ghost miners up and plugged them in at my own place, but also there they don't show up.

Does anyone have a solution for this problem? Please....

Francis

There is an SDCARD in the Baikal X10.
Just removethe cables and remove the screws.
You will see the OrangePi Zero.The SDCAD is located behind the CAT5 interface.
You cannot modify SDCARD image by using USB. USB is for the updating the MCU firmware for the boards.

-

Before doing anything, just power off the PSU and power ON it again.
You will find them on Baikal monitor. I use smart plugs to restart the Baikal miners.