Quote from: martyshmoo on December 18, 2017, 03:13:32 AM

Quote from: martyshmoo on December 17, 2017, 02:33:59 AM

Quote from: jtthornton on December 16, 2017, 12:57:55 AM

Was the beta v2.02 not meant to run for any length of time? I ran it for ~10 hours and for some reason my Chain 3 is much worse now in terms of HW failures. I set it on the lowest voltage and before I ran the beta (but ran many different Blissz firmware updates before that) it was fine around 450. Now it can't get above 419 without multiple HW failures per minute. Anyone else experience this?

I'd like to add that I've been very happy with what Blissz has been able to do thus far, so thank you!

Yep, that's my problem too.

I have a new highly sensitive chain that WAS my best chain, now is my worst.

I am afraid the aggressive freq/voltage search during autotune screwed my machine/chain up.

No answers? I cannot mine at speeds higher than 19 now, I was at 20.9 before.

It looks like they auto tuned themselves right out of being tuned...

Can I get an answer to one question.

Should I ignore HW errors when temps are ok?

Info: Newly rebooted New version of 10/12. Set everything as described.

This goes on at a pace of 118 every 20 minutes or so.

Chain# ASIC# Frequency MH/S(RT) HW Temp(PCB) Temp(Chip) ASIC status
1 60 494 6026.14 0 54 71
oooooooo oooooooo oooooooo oooooooo oooooooo oooooooo oooooooo oooo
2 60 438 5400.08 118 47 61
oooooooo oooooooo oooooooo oooooooo oooooooo oooooooo oooooooo oooo
3 60 494 6154.90 0 57 72

When I installed Beta, did a test at lowest, did a test at 9V sent you the stuff.

I tried 12 or 13V with autotune and immediately saw a temp of 256 on the Chain 2. Chip temp was fine....(I mean like 79).

I reverted back to old 12 /10 that I had. Now chain 2 overreacts to temps. I just disregard as long as no asic fail and no shown temperatures to worry about. But watching it Hurts.

Is there a way change temp offset for chain two only to like -13? It's at -3 now, just like the other two.

Thanks for your answers in advance, sorry to bother you.

M

Well, due to the overwhelming responses and help I get, this is what I did, Ignore them....

Chain# ASIC# Frequency MH/S(RT) HW Temp(PCB) Temp(Chip) ASIC status
1 60 556 6896.92 0 53 73
oooooooo oooooooo oooooooo oooooooo oooooooo oooooooo oooooooo oooo
2 60 537 6623.69 278 50 68
oooooooo oooooooo oooooooo oooooooo oooooooo oooooooo oooooooo oooo
3 60 531 6611.15 0 56 73

Works fine for hours now.

Still need a fix, if there is a possibility for one.

Thanks, again, in advance, kindly, for any response, or help provided to me.

Patient 1

M