Quote from: PacoSS on December 17, 2017, 07:47:02 PM

Do it allow to change the original fans?

Cause I tried change them (Noctua nf-f12) and the machine didn't start at all :-(

I didnt like of the Blizz one that it disconnect from the pool i'm minning to make the dev job, and that's is heavy penaltied there.

Thanks.

Yes you can set the fan slope by increasing or decreasing the max fan temp and min fan temp
Edit I missed this as well sorry I'm at work and reading fast.
I'll add support for 0 rpm fans in the next release

Quote from: wolf_miner on December 17, 2017, 01:28:28 PM

Hi, is possible to pass the voltage settings using ssh commands instead of using web interface?

Cheers W_M

Kinda if you modify the file /config/cgminer.conf then restart cgminer you should be good

Quote from: Edrick123 on December 17, 2017, 11:35:41 AM

For the voltage can I do it for individual board with tons of hw? Or the voltage setting is for all 3 board?

Try all permutations of frequency and voltage

Edit I misread this. Yes I'm working on individual board voltage I just need some modivation to finish. No eta yet