Quote from: huntingthesnark on December 19, 2017, 12:01:10 PM

Quote from: markcarline2 on December 19, 2017, 11:18:11 AM

Quote from: huntingthesnark on December 19, 2017, 10:55:04 AM

Quote from: markcarline2 on December 18, 2017, 11:59:06 AM

Quote from: huntingthesnark on December 18, 2017, 11:48:50 AM

Just a quick note for Moonlander folk in UK and Europe - Am currently using this Plugable 7-port hub with x4 sticks, running fine so far: http://[Suspicious link removed]/2zkGMOu

Tried this Orico number: http://[Suspicious link removed]/2jdmoGn failed at more than two.

I have the same setup, you going to try 5x ? Also what speeds you running ?

I'm aiming for 6, 2 more sticks in the post. Running at 720 at the moment, stable, 4MHs per stick. Can obviously go higher, sink temps at mid 60's... Will post what happens with 6!

Ok. I have three more in the post on top of the four I have connected now. I think it's just a matter of speed & amps that each one draws in order to get all seven running. From my post on page two if this thread I think (in theory) we have 1.71a to play with per port...

"If you were to split all 7 ports up equally and assuming 100% efficiency you could in theory draw about 1.71A per port."

What we could do with is accurate amp / speed table for these.

Yes indeed. As a side note, I used these 90-deg adaptors http://amzn.to/2yXp5Ba so the ports that were blocked are accessible. Should have got the left hand version really (for the hub to be right way up) but the build quality seems pretty good.

I went with these 30cm ones, cable seems thick enough..

https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.co.uk%2Fulk%2Fitm%2F282430334062