Quote from: kimdonghwan on December 26, 2017, 05:19:23 AM

Quote from: tropulus on December 25, 2017, 10:39:58 PM

I'm using flypool and DSTM.

Your --user should just be your wallet adress, nothing else.

This is my line:
zm --server eu1-zcash.flypool.org --port 3333 --user t1XtiGPVNy8nz9BgxHVj9v2nCoaHe7sqq8U

Then how do i determine the worker name? say i have two rigs: worker1 and worker2
Thanks

Quote from: PickAxe131 on December 25, 2017, 10:49:36 PM

Check outgoing and incoming traffic through your router. Im using EU Flypool with no problems at all. There are more users here that uses Flypool.

Thanks..but i have no problem with EWBF, internet is very stable 24/7..either it is EU or Asia Flypool, port 3333 or 13333, EWBF runs smoothly..
DSTM is the problem here..

Quote from: QuintLeo on December 26, 2017, 01:20:31 AM

When I did my dstm testing, I was using flypool - WITH a worker address.

Your problem is NO PASSWORD.
Try adding "--p x" to the end of your command line in the bat file.

The README says:
--user Username / Workername

Does it mean Wallet / Worker? not Wallet.Worker (using "slash" instead of "dot") ??

Quote from: captaindiptoad on December 26, 2017, 02:02:01 AM

The problem is not "not having a password"

I run fly-pool with no password. no problem. I have the same settings as tropulus (aswell as 3 workers).

But how did you determine the Worker name?
Tropulus did without WorkerName..say i have two rigs with same specs, i won't be able to know which one is active or down..
Thanks btw..

What I meant is the traffic for dtsm, a couple pages earlier there was a user with the exact same problem as you. The problem was that he's router ASUS AC-88 something updated the firmware and he needed to give dtsm acccess to internet again.