Quote from: MagicSmoker on January 02, 2018, 12:57:03 PM

Apologies if this was covered in the previous 18739 posts, but I want to understand the devfee mining process better as it seems I am getting unduly penalized because I am mining an ETH fork, Ubiq, and to a different pool than what Claymore uses for the devfee.

For example, I just restarted Claymore at 6:50AM and it immediately launched into mining the devfee, then it switched over to Pool.Sexy to mine UBQ for me, taking about 72 seconds in all to do so. At 7:44:23 it once again switched over to mining the devfee, so less than an hour later (granted, not much less, but still less), and the total time it took before resuming mining for me was again at least 72 seconds. And yes, this is in single mining mode, since I don't have much interest in roasting my GPUs just to mine a shitcoin like SIA.

I understand that if I were mining Expanse I could save some wasted time for devfee mining by using the DAG for that coin - e.g. -allcoins EXP; is there a similar option for UBQ? If not, then Claymore 10.2 is just marginally faster for me than Ethminer 0.12.0...

It looks like you answered your own question: "e.g. -allcoins EXP". And there is no need to scroll through 18k posts: The same question was answered on the very same page TODAY by Coroto