Quote from: thin on January 11, 2018, 05:13:15 AM

Quote from: zawawa on January 10, 2018, 08:57:44 PM

Quote from: thin on January 10, 2018, 08:23:56 PM

Quote from: zawawa on January 10, 2018, 08:08:07 PM

Quote from: thin on January 10, 2018, 07:50:16 PM

Hello,
I'm new to this miner.
I have a rig of 6 rx580, it is working fine with gatelessgate , and shows rates around 900-930 on cryptonite. However with gateless gate Sharp I observer strange behavior - only 1 card starts at full speed, one with about half speed, other either do not start or starts at very low speed.
Could you please advice.
Thanks

I would suspect the driver first. The only officially supported driver is Adrenalin 17.12.2.
There is a button to download it on the "Misc." tab page.

That what I thought first too. I had blockchain driver before, used DDU and updated to recommended. It didn't help.

Did you turn off CrossFire and switch GPU Workload to Compute for every card?

I've switched to Compute load, but I can't locate Crossfire setting in 17.2.2, can someone point me to the right place?

Another problem with recommended driver - which MSI afterburner supports it?

Found an article on Reddit they say to access it from display tab>>additional settings.
https://www.reddit.com/r/Amd/comments/43wok1/1611_how_to_disableenable_crossfire/
But if you haven't enabled it I don't think you need to disable it.

MSI Afterburner does not work with Adrenalin 17.12.2 any longer.