Quote from: bigolin on January 17, 2018, 07:12:44 PM

Quote from: Jeremiah1610 on January 17, 2018, 07:00:05 PM

Quote from: bigolin on January 17, 2018, 06:51:37 PM

Anyone here using Awesome Miner to monitor their miners?

I'm having an issue with the notification settings. The software allows you to set up rules such as Temp rules for automatic shutoff, warnings for certain set temps (you can even select chip temps vs board temps). The issue I'm having is I am not being alerted when the set temps are met on any of the miners. I'm not sure if there is a step I'm missing in applying the rules to each miner, etc.

Just curious if anyone has experience with the software that could help a brother out. I have ensured that the rules are enabled, and I have verified that the temps are set correctly and that the miners are actually at or above the temps with no warning.

Also along the same note, at what point do you get nervous for your chip temps? I know each person probably has their own temp they begin worrying about, I'm really just looking for what should be worrisome, and what would be catastrophic.

Fellow newbie here, only a week in. I've heard the self shut off for the miners is 90-100. I don't use awesome miner, can't help you there. As far as when I get concerned: One of mine when it reaches 78 on the main board will kick fans up to 6k rpm which then cools it to 75 rapidly, the fans go back to 4k rpm, and a few minutes later it is a rinse and repeat cycle. So when that one reaches 77 I go open the doors and let some heat out. My coolest one runs almost 10 degrees cooler for some reason, so I can't complain there. And my middle one the exhaust fan always run 5.2k-5.6k rpm constantly. (my next project figuring out that). Hope this helps.

Thanks for the response. That totally helps with figuring out where everyone's numbers are. Some people say they let their chip temps run up to almost 100C in the summer time and the miners are fine but I'm not comfortable with that at all. So far the highest I have seen is around 85C and I immediately cool them down at that point. I am currently using my garage until I have a shed built with an exhaust fan and an area to separate my cool and hot side. Currently the miners heat up the garage and i pop the door to let some heat out of the room until it heats up again.

my new avalon 741 are automatically running @80-90 degree
fanspeed between 40-60%
Most time they're running on a constant level.
Not like the shitmain s9 which is turning up and down every 5 mins...