Quote from: kristikun on January 22, 2018, 12:55:10 PM

Hello guys I´v been using D3 for some time now with custom firmware i never had any problems i was OC it for 3 months but tempratures were ok all the time. but now one of my chains didn´t show up so i reseted and noticed i get around 80HW per sec on 1 chip which normaly had 60 ASICs but now it shows 54 , tryed to reflash firmware , reconent cables and now i get 55 asics : the thing is the hashing board is working fine had it running for 2 days with bilions of HW before the chain ddoesnt show up , i just reboot it and its running again but with shitloads of HW it seems to be hardware problem with hashing boad my D3 is not under warranty anymore so should i just let it run with those HWs waiting for the chip to burn ? or is there any way to fix it ?

Yeah, same problem (likely you are running on 120v like me) what I found works is sometimes increasing the voltage on the board by 1-2 and lowering another board that works by 1-2. Then I found out switching from "silent" to "performance" or vice versa kicked all 60 back up.

Lmao I have thousands and thousands of hardware errors. They all come because of being on 120 volts... it sucks.