Quote from: tekmobile on January 22, 2018, 06:19:20 PM

Quote from: crisandi on January 22, 2018, 02:36:52 PM

Something is happening with one of my rigs.
SMOS doesn't want to recognise it anymore, no matter what I do, rewrite the program, change the pools, this rig starts, I can see it working, just SMOS doesn't see it so i cannot configure the pools and everything. I think I should just get back to using windows, at least the rig worked after I restarted it and I didn't have to try to guess everytime what's wrong.
What might be the problem?

Maybe a bad USB drive ive had a few go on me that started to fail to boot reflashed and it was ok for a bit then same again so I replaced it and it's been working since

They were not cheapo no name ones either they were decent USB3 sandisk sticks if SMOS is writing to the drive quite a bit then I guess they can fail in time flash memory only has limited write cycles

Thank you, I am also using quite good corsair usb, I will try to buy new ones and test again