Quote from: tarui on August 10, 2013, 03:47:01 PM

i see some users running at 350mhz for batch 2?

is it possible to run at greater than 350mhz, at 360mh? for batch 1 with say 1250w 80+ gold psu?

previously it was running at 345mhz on a 1000w psu

so i got a new 1050w and was thinking if i should return and exchange it for a 1250w psu instead for greater hashing rate and make up the shortfall(downtime)

I am running batch 2 3 modual system with 860W Corsair AXi Series 80PLUS Platinum Modular Digital Power Supply am so far close to taking it to the mark of 400MHz per chip I have so far tested upto 360MHz rock solid and thinking to increase and temps at a good rate too then again I have also done air flow mods to it to improve channeling of airflow to the modules.

If you are on a 4x moudal I am unsure what to set too as I have seen a lot of people having problems taking above 340MHz due to amount of power it sucks up. I am running 3 at 360 to 365MHz and only taking 760 intake feed of power and using only 700 of it so this Platinum psu is very energy effective while temps never going over 50c Am also wondering if I can get to that target of 400MH/s per chip but even then that's pushing it way too much but will see as I have full monitor status of unit of how much each modual is sucking up and how much amps its using.

Quote from: BitSyncom on June 25, 2013, 04:11:37 AM

was wondering how long it'd take people to notice ( and more importantly share the constant that we've released on github.)

the number you are all aiming for is 450 Tongue

of course, that's not really possible on just air cooling.