Quote from: grosminer on February 15, 2018, 02:32:07 PM

Quote from: crypto_curious on February 09, 2018, 10:13:21 PM

Quote from: grosminer on February 09, 2018, 08:40:52 PM

Anyone tried that kind of ports:
http://a.co/dzWEFEE

This is just standard USB front, with USB 3.0 cable which goes to motherboard. It will give you only what specification says. Wikipedia says that about USB 3.0 power specs:

Quote

Power and charging

As with earlier versions of USB, USB 3.0 provides power at 5 volts nominal. The available current for low-power (one unit load) SuperSpeed devices is 150 mA, an increase from the 100 mA defined in USB 2.0. For high-power SuperSpeed devices, the limit is six unit loads or 900 mA (4.5 W), almost twice USB 2.0's 500 mA.[10]:section 9.2.5.1 Power Budgeting

USB 3.0 ports may also implement other USB specifications for increased power, including the USB Battery Charging Specification for up to 1.5 A or 7.5 W, or, in the case of USB 3.1, the USB Power Delivery specification for charging the host device up to 100 W.[12]

You will get something similar, not more than that.
I tried 2 Moolanders on my USB 3.0 front from my Fractal R5 case. They can work just fine at 756MHz. I wouldn't try anything above that, I don't want to fry my motherboard Cheesy

Thanks for the infos.

I just want to find a good hub that can run 4 Moonlanders 2 and >100$ .. not sure if it's possible

Shared my experience with $25 hub (comes with 20W adapter so could handle 4 MLD2 at decent clock).
see:

Quote from: Bitfort on January 10, 2018, 06:55:47 AM

I'm running 3 sticks on digitus 10 port https://www.digitus.info/en/products/computer-accessories-and-components/computer-accessories/usb-hubs/da-70229/ ... running fine at 832 MHz ( 4.7 MHs, HW around 1%)

Hub has room to accomodate 6 sticks but you would need to underclock them as the power supply is only 5V 4A.