Quote from: zipiju on September 04, 2013, 10:06:29 PM

Quote from: terrahash on September 04, 2013, 06:08:53 PM

Quote from: zipiju on September 04, 2013, 09:24:53 AM

Quote from: terrahash on September 04, 2013, 04:38:40 AM

Quote from: hf_developer on September 03, 2013, 09:01:55 PM

Quote from: terrahash on September 03, 2013, 08:47:50 PM

It is most likely a hardware bug in the circuit. During our testing we realized that the Dual NOR gates used in the design are too fast, and there needs to be some propagation delay. Using a cheap NOR gate chip from Fry's did the trick. We are still trying to see if this can be fixed in the firmware.

Maybe you may also want to try to use a bigger capacitor for the phase shifter in front of the NOR gate. A circuit should not depend on the propagation delays or fabrication tolerances of logic gates. I also tried to use the internal comparator of the PIC as a NOR gate, which is even better since it has some clock synchronization register. But it has shown that the comparator is not fast enough...

Already tried using bigger capacitor. Does not work. The only work around we have found is using a slower gate, so far.

I'm sorry to tell you, but you're wrong.
I'm using v0.3.1 board with bigger cap (currently about 260pF) and it's hashing quite well.
Without it, the clock signal is not delayed enough - just about 5ns and bad nonces are returned.
BTW terrahash, what modifications did you made to the 4 chip firmware to hash with all 16 chips?

You are using 260pF for C274 right?

In order to hash with 16 chips, you need to make the following modifications in klondike.c, from line 159:

Code:

Status.ChipCount = 16;

// pre-calc nonce range values
BankSize = (Status.ChipCount+1)/2;
Status.MaxCount = WORK_TICKS / BankSize / 2;
NonceRanges[0] = 0;
for(BYTE x = 1; x < BankSize; x++)
NonceRanges[x] = NonceRanges[x-1] + BankRanges[BankSize-1];

Yes thats correct.
Thanks for the code, will try it out.
BTW, have you tried connecting more than one K16 to CGM?

I2C code is not working out of box. Thats exactly what we are working on right now.